Power Pack & Submersible Pump

The HydroSub consists of a diesel engine power pack that hydraulically drives the portable floating submersible pump.

The submersible pump pushes (no suction) the water through the large diameter flexible hose. The level of the water supply can be up to 60 meters below the power pack, depending on the model of HydroSub.

NO DRAFT PROBLEM ANYMORE The submersible pump is linked to the power pack by two 60 metre long hydraulic hoses, allowing access to any open water source at a 60 metre distance from the power pack either horizontally or vertically. Unlike a standard fire truck or fire draft pump that has to stand very close to the water and is limited by the draft issue as it uses suction to draw water.

Additionally the pump is capable of pumping salt water, chemically polluted water, mud, dirt, and can operate in shallow water with no risk of pump failure due to cavitation. It can also be used in conjunction with a mobile desalination plant and/or mobile water treatment plant.The fact that the pump is especially designed for long distance relays, with an extreme FLAT CURVE, contributes also strongly to the success of the system.


  • HydroSub 60:
  • HydroSub 60 with Flood Pump:
  • HydroSub 150:
  • HydroSub 150 with Flood Module:
  • HydroSub 450:
  • HydroSub 550:
  • HydroSub 900:
  • HydroSub 1200:
  • 1,500 L/min at 10 bar
  • 20,000 L/min
  • 3,500 L/min at 10 bar
  • 50,000 L/min
  • 11,000 L/min at 12 bar
  • 14,000 L/min at 14 bar
  • 24,000 L/min at 12 bar
  • 30,000 L/min at 12 bar

To contact FFT with your requirements including access to open water, capacity, distance to be covered in metres, elevation, etc, please click here This will enable FFT to assist you choosing the optimum configuration for your site.

HYTRANS Mobile High Volume Flood Pumps