Boxwall® Flood Barriers

Flood-fighting Made Simple. Quick & Easy. Safe & Secure.

Boxwall® Flood Barriers

Boxwall® Specifications

Applications

  • Faster and more effective than sandbags 
  • Ideal for flash-flood response in streets, pathways, and roads
  • Flexible, extendable system with corner units
  • Minimal labour required
  • Rapid deployment for emergency protection
  • Ideal for car parks, building access points, and entries
  • Cost-effective compared to sandbagging
  • Designed for rough and even surfaces
  • Ideal for protecting large sites 
  • Can be deployed on concrete or asphalt surfaces
  • Available in two sizes 
  • Stackable for efficient storage 
  • Diverts or contains floodwater

Benefits of Boxwall®

Emergency Deployment

Two people can set up a 100m long flood barrier in under 25 minutes

Lightweight & Portable

Mobile containment system designed using “book-end principle” technology

Flexible Barrier Design

Use +/-3° flexible couplings and corner units for curves and bends

Safe & Secure

Flood-fighting containment made easy, simple, and quick

Clean & Store

Hose down, dry, stack

Scalable & Efficient

Reduces flow velocity and disperses energy

A Better Option Than Sandbags for Floods

Sandbags have been a traditional tool for flood defence – but they are labour-intensive, slow to deploy, and single-use.

Boxwall® delivers faster, cleaner, and more reliable emergency protection.

Each unit is lightweight, reusable, and built to rapidly connect into a temporary flood wall wherever and whenever water threatens.

Floods result from a course of events controlled by forces of nature that can only be controlled to a limited degree. Furthermore, no two events are the same, which means that all protective equipment must be used not only with good knowledge of its function and limitations, but also with generally sound judgement.

Those who provide the equipment, manufacturers, resellers, hirers, etc. can never accept liability for the actual use and any possible personal injury or damage to property that might arise.

What are boxwalls made from?

The Boxwall® units are made from tough yet flexible polypropylene.

The BW52 can withstand flood water levels up to 50cm (500mm/0.5metre/20inches).

The BW102 can handle flood water levels up to 100cm (1000mm/1metre/40inches).

The Boxwall® is primarily designed for urban areas. It is ideal for hard surfaces like concrete, asphalt, bitumen, or pavers.

If you plan to use them on other surfaces, note that there may be seepage through the gaps between the Boxwall® and the ground. In these cases, you can use a plastic sheet to lay over the Boxwall® units and on the wet area – covering a few metres – to reduce the effect of possible seepage.

Get in Touch With Us

Find out about the best emergency solutions for your projects. You can request a free quote by submitting the form on this page, or get in touch using the following methods: